
Steam Natural Circulated Industrial Heat Recovery Steam Generator for Industry
Product Introduction
Features
1. High safety and reliability:
Conventional heat exchange equipment is generally interwall heat
transfer, hot and cold fluid flow on both sides of the wall, such
as pipe wall or wall leakage, will cause production loss.
Heat pipe waste heat regenerator is secondary interwall heat
transfer, that is, the heat flow through the heat pipe evaporating
section of the wall and the condensing section of the wall to reach
the cold fluid.
2. The heat pipe waste heat recovery device has high heat transfer
efficiency and remarkable energy saving effect.
3. The heat pipe waste heat recovery device has good corrosion
resistance
The temperature of the heat pipe wall can be adjusted, and the
temperature of the heat pipe wall can be adjusted above the dew
point of the low-temperature fluid through proper heat flow
transformation, so as to prevent the dew point corrosion and ensure
the long-term operation of the equipment.
Because avoid flue gas dew point, so that dust is not easy to
adhere to the rib and pipe wall.
At the same time, the heat pipe will generate self-vibration in the
heat conduction, so that the ash is not easy to adhere to the tube
wall and fin, so it will not block the ash.
4. Flexible installation and structural arrangement:
The installation of heat pipe waste heat reclaimer does not need to
change the original process system, and the structure design and
position arrangement are very flexible, which can adapt to various
complex occasions.
5. Long service life:
The service life is more than 10 years, single heat pipe can be
removed and replaced, simple maintenance and low cost.
6. Short payback period:
The total investment can be recovered in six months to one year.
Working Principle
Its working principle is shown in the figure below: the left is the
flue gas channel, the right is the clean air (water or other media)
channel, there is a partition in the middle to separate each other
without interference.
High temperature flue gas by the left channel discharge, discharge
when the high temperature flue gas flushing tube, when the flue gas
temperature 30 ℃ >, heat conduction, heat pipe is activated
automatically to the right, then the left heat pipe heat absorption
and temperature drop after high temperature flue gas flowing
through the heat pipe, heat is absorbed by the heat pipe and to the
right.
Room temperature clean air (water or other media) under the action
of the blower, flow along the right channel in the opposite
direction to wash the heat pipe, then the right side of the heat
pipe heat, the clean air (water or other media) heating, air flow
through the heat pipe temperature rise.
Parameters
Cement production line capacity t/d | 1000 | 2500 | 5000 | 10000 | |
Boiler inlet flow Nm3/h | Kiln(front) | 60000 | 88000 | 243000 | 472000 |
Kiln(tail) | 76000 | 170000 | 328000 | 612000 | |
Boiler inlet gas temperature℃ | Kiln(front) | 370 | 360 | 380 | 390 |
Kiln(tail) | 360 | 320~360 | 330 | 330 | |
Rated evaporation t/h | Kiln(front) | 5.8 | 7.25 | 24 | 50 |
Kiln(tail) | 7.5 | 10~15.8 | 20~24.6 | 35.5 | |
Rated steam pressure Mpa | Kiln(front) | 1.25 | 1.25 | 1.25 | 1.25 |
Kiln(tail) | 1.25 | 1.25 | 1.25 | 1.25 | |
Rated steam temperature℃ | Kiln(front) | 340 | 330 | 350 | 360 |
Kiln(tail) | 340 | 300~340 | 310 | 310 | |
Boiler structure | Kiln(front) | Vertical | Vertical | Vertical | Vertical |
Kiln(tail) | Vertical | Vertical and Horizontal | Vertical and Horizontal | Vertical |
Company Information
Hua Dong Boiler has become a major qualified supplier of domestic and foreign boiler manufacturers and energy companies, including American Covanta Energy Company, AMEC Foster Wheeler Company, ALSTOM, Oriental boiler Limited by Share Ltd., Harbin electric LLC, Wuxi Hua Guang Boiler Co., Ltd., Hangzhou Boiler Group Co., Ltd.
Zhangjiagang HuaDong Boiler Co., Ltd.
Hua Dong Boiler Co., Ltd. is a high-tech enterprise specialized in manufacturing boilers. Established in early 1985s, has two manufacturing bases, this company covers 400,000㎡ with fixed assets amounting to USD 110,000,000. There are 1100 employees including 150 technicians and 600 coded welders. Hua Dong holds the manufacturing licenses for Grade A boilers and Grade A1&A2 pressure vessels issued by Chinese General Administration of Quality Supervision, Inspection and Quarantine; also it holds the "S" and "U" "NB" stamps issued by American Society of Mechanical Engineers; meanwhile, this Company has passed the certification of ISO9001, SO3834, EN12952 Quality Management System.
"Hua Dong" boilers include Utility Boiler, HRSG Boiler, coal-fired , oil(gas) -fired, coal-water-slurry-fired and garbage-fired steam/hot water boilers, organic heat carrier boilers, etc., and Boiler spare parts (Economizer, Finned tube, Header, Steam drum, Superheater, Water wall panel, Air preheater, Cyclone separator, etc., which are widely used in power generation, heat supply, chemical engineering, textile, food, paper, road building, plastic, rubber and wood working industries. "HD" boilers are honored as "Famous Production in Jiangsu Province", " Jiangsu High-Tech Product" and "Jiangsu Energy-Saving Product". "HD" brand is a "Famous Brand in Jiangsu Province". We are a qualified supplier for the top three boiler manufacturers in China(Harbin Boiler Co., Ltd., Dong Fang Boiler Group Co., Ltd., Shanghai Boiler Works Ltd.,). So far, Hua Dong Boilers have served 10000 customers, which sell well all over China and are exported to USA, Australia, Russia, Kazakhstan, India, Indonesia, South Africa, Brazil, and Southeast Asia.
We strive to manufacture "Safe, Efficient, Energy-Saving and Environment-Friendly" boilers, provide new-type products in excellent quality, serve users sincerely to their satisfaction, and be a top supplier of boilers in China.
Declaration
Zhangjiagang Hua Dong Boiler Co.,Ltd has no subsidiaries.
Packaging & Shipping
Company Business
Our products have been wildly used in power plants and large international companies overseas.